B-8 Setting System Board Jumpers
3.
Locate the Password Clear jumper J1K2 (A) on the system board (see
Figure B-1).
You may have to remove any installed expansion boards to access the jumpers
(see “Removing Expansion Boards” in Section 3).
4.
Move the jumper block to the Password Clear position (see the following
figure).
Figure B-6 Clear Password Jumper
5.
Replace the system unit cover (see “Replacing the Desktop Cover” or
“Replacing the Minitower Cover” in Section 3).
6.
Connect system power cables and monitor.
7.
Power on the system. The system lets you boot the computer.
8.
Power off, unplug the system and monitor, and remove the cover.
9.
Return the jumper block to the Password Enabled position.
10.
If you removed any expansion boards, replace them (see “Replacing Expansion
Boards” in Section 3).
11.
Replace the system unit cover.
12.
Power on the system.
13.
Run Setup to set a new password (see “Setting System Parameters” in
Section 2).
PCI EXPANSION SLOTS
The following jumpers are set for the system in manufacturing. These jumpers set the
number of PCI slot available to you. Use the information in the following figure for
verification purposes only.
Password Clear
−
J1K2
Password Enabled (Default)
Jumper 1-2 (A)
Password Clear
Jumper 2-3 (A)
1 3 1
A B
4
6 4
1 3 1
A B
4
6 4
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...
