3-30 Option Installation
1.
Remove the system cover.
2.
Remove the screw securing the drive bracket to the chassis (see the following
figure).
3.
Slide the bracket to the rear of the chassis to release it from the three bracket tabs.
4.
Carefully lift the drive bracket up and place it on top of the power supply. Avoid
pulling on the installed drive cables.
Figure 3-30 Removing the 3 1/2-Inch Drive Bracket
Installing the Desktop 3 1/2-Inch Drive
Install the hard disk drive into the drive bracket as follows.
1.
Remove the system unit cover.
2.
Remove the 3 1/2-inch drive bracket from the system unit (see “Removing the
Desktop 3 1/2-Inch Drive Bracket”).
3.
Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
4.
Insert the hard disk drive so that the connectors extend out of the bracket on the
same end as the standard diskette drive connectors.
5.
Align the holes in the hard disk drive with the holes in the bracket.
6.
Secure the device to the bracket with the four screws, two to a side, that come
with the device.
Summary of Contents for POWERMATE P2166
Page 217: ...Index 4 ...
