3-22 Option Installation
Installing the 3 1/2-Inch Drive
Use the following procedure if you are installing a second 3 1/2-inch hard disk drive into the
system.
1.
Remove the system unit side panel (see “Removing the Side Panel”).
2.
Remove the 3 1/2-inch drive bracket from the system unit (see “Removing the
3 1/2-Inch Drive Bracket”).
3.
Follow the preinstallation instructions that come with the device, such as setting
jumpers and switches.
4.
See “Device Preparation” for device preparation information.
5.
Insert the hard disk drive so that the connectors are extended out the bracket on
the same end as the standard diskette drive connectors.
6.
Align the holes in the hard disk drive with the holes in the bracket.
7.
Secure the drive to the bracket with the four screws that come with the drive
(two screws on each side).
Figure Section 3-10 Securing a 3 1/2-Inch Drive
8.
Continue to “Replacing the 3 1/2-Inch Drive Bracket.”
Summary of Contents for POWERMATE P - SERVICE MANUAL 1995
Page 37: ...1 22 Technical Information ...
Page 169: ...Index 5 ...