AD-25182501
CHAPTER 3
Page 109
Revision 1.0.1
NAP- 200-009
Sheet 2/3
System Initialization and System
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
Data Entry
2.
System Data Entry
• There are two methods for data entry, both of which employ a CAT or a MAT.
2.1
CAT (Customer Administration Terminal)
Any D
term
can be assigned as a CAT terminal through programming. The D
term
can still be used as a regular
telephone when it is not in CAT mode. If the system is initialized by “C” (Resident System Program), every D
term
will be able to go into CAT mode. If the system is initialized by “B” (All Clear), only LEN0000 is assigned as a
CAT port (the LDC card must be installed in slot LT00).
To assign a D
term
as a CAT, follow the procedures shown below.
To set CAT mode:
1.
Press
2.
Press
- CNF lamp flashes
3.
Press
- CNF lamp is off
4.
Press
5.
Press
- CNF lamp flashes
6.
Press
- CNF, SPKR, ANS lamps are lit
- “CAT MODE” is displayed on LCD
7.
Press
- “COMMAND = -” is displayed on LCD
Note:
Steps 1 to 6 need to be completed within four (4) seconds.
TRF
CNF
*
TRF
CNF
#
ST