Smooth Operator Configuration Note (77175)
NEC Neax 2400 w/ Direct Serial Link
C o n f i d e n t i a l
P a g e 3
The above information is provided by Octel Communications Corporation as a guide.
See disclaimer on page 1
O c t e l C o m m u n i c a t i o n s
Intercom
Paging
[
9
]
Record Telephone Conversation
[
]
4.1 DISCONNECT
TYPE
Disconnect is achieved by either Drop in Loop or Fast busy. For proper
external disconnect supervision, Ground start or Supervised Loop start CO
lines are recommended.
(see Note 7.1)
5.0 CONFIGURING THE NEC NEAX 2400
Before you begin programming, it is recommended that a hard copy of the
customer database be obtained to verify existing programming.
When configuring the MCI link, the switch system administrator should be
contacted to avoid possible programming conflicts. Remember to instruct
the SWITCH that the MCI is not a MAT terminal.
Note: In the following examples, 100 will represent the UCD pilot number
for Voice Mail. Single Line extensions to the Smooth Operator will be 100,
101, 102 and 103.
5.1 NEAX 2400 SYSTEM PROGRAMMING
Refer to the Programming section in the NEC manual for information on
entering, saving, and exiting database programming.
To allow multiple call forward to personal greeting, enter system
programming. Data will specify the number of hops allowed on calls
forwarded under Busy/No answer conditions.
Assignment of System Data
SYS :
1
SYS:
System Data Items
INDEX :
5
DATA:
XX
1-System Data 1
2-System Data 2
3-System Data 3
INDEX:
System Data Index
System
Index
1 0-255
2 0-15
3 0-31
DATA:
System
Data
(Hexadecimal)
SYS:
Number of hops allowed on calls forwarded is a system-wide
parameter,
type
1
in this field, then press
ENTER
.
INDEX:
Enter
5
for number of hops allowed on calls forwarded.
DATA:
Max value allowed is 05 for 5 hops. Consult the System
Administrator for proper value.
Programming switch system
parameters
