Smooth Operator Configuration Note (77175)
NEC Neax 2400 w/ Direct Serial Link
C o n f i d e n t i a l
P a g e 1 2
The above information is provided by Octel Communications Corporation as a guide.
See disclaimer on page 1
O c t e l C o m m u n i c a t i o n s
DATA:
Selecting
01
in the DATA field insures that the port is seen as a
MCI port and not a MAT terminal interface, then press
ENTER
.
FIVE: ASSIGN THE MCI LINK TO THE UCD GROUP
Assignment of System Data
SYS :
2
TN:
1
SYS:
System Data Items
INDEX :
6
DATA:
01
1-System Data 1
2-System Data 2
3-System Data 3
INDEX:
System Data Index
System
Index
1
0-255
2
0-15
3
0-31
DATA:
System Data (Hexadecimal)
SYS:
MCI data link association with a UCD Group is on a tenant by
tenant basis. Type
2
in this field, then press
ENTER
.
TN:
You need to use the same tenant value you used when creating
the Single Line ports and UCD group.
INDEX:
Index
6
includes field that allow you to associate the MCI link
with the UCD group.
DATA
: Setting DATA to
01
sets bit 0 to tell the Switch that the MCI link
is associated with the UCD group.
MCI SERVICE FOR CALLS VIA ATTENDANT CONSOLE
Assignment of System Data
SYS :
2
TN:
1
SYS:
System Data Items
INDEX :
7
DATA:
00
1-System Data 1
2-System Data 2
3-System Data 3
TN:
Tenant
Number
INDEX:
System Data Index
System
Index
1
0-255
2
0-15
3
0-31
DATA:
System Data (Hexadecimal)
SYS:
MCI Service for calls Via Attendant Console is on a tenant by
tenant basis. Type
2
in this field, then press
ENTER
.
TN:
You need to use the same tenant value you used when creating
the Single Line ports and UCD group.
INDEX:
Index
7
includes the field that allow MCI Service for calls via
Attendant
Console.
