NEC N8800-103F, User Manual

Page: 86 / 136

4-38 Windows Setup
Step 12: Set Network for NEC ESMPRO Agent
NEC ESMPRO Agent is required for continuous operation of the NEC Express5800/ft series. It is
automatically installed when you install the OS.
To operate NEC ESMPRO Agent, you need to set the SNMP.
To change the settings of the SNMP Service:
1.
Double-click [Administrative Tools] in [Control Panel].
2.
Open [Services] in [Administrative Tools].
3.
Select [SNMP Service] from the service list and then [Properties] in the [Action] menu.
The “SNMP Properties” dialog box appears.
4.
Enter “public” in the [Community name] box in the [Traps] property sheet and click the
[Add to list] button.
IMPORTANT:
„
If you changed the community name of traps to be received from the default “*” in
the NEC ESMPRO Manager site, enter the same name as the community name
newly set in the NEC ESMPRO Manager site.
„
To receive trap from NEC ESMPRO Agent at the NEC ESMPRO Manager
machine, both community names should be the same.
5.
Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC
ESMPRO Manager machine of the send destination in the [Host name, IP or IPX address]
box, click the [Add] button.
IMPORTANT:
If the IP address (or host name) of the remote NEC ESMPRO
Manager is specified as the trap send destination in the setup of the manager report
(TCP/IP), the message warning the duplication appears. The specification of the same
NEC ESMPRO Manager causes to be reported doubly.
6.
Open the [Security] property sheet and make settings as follows:
•
Add the community name entered in 4 to [Accepted community names].
•
Set its authority to [READ CREATE] or [READ WRITE].
•
Select [Accept SNMP packets from any host].
IMPORTANT:
„
If you entered any community name other than “public” in 4, add that name to
“Accepted community names.”
„
Unless you set the acceptable community’s authority to “READ CREATE” or
“READ WRITE,” you cannot perform monitoring from NEC ESMPRO Manager.
< Setup of receiving SNMP packets from specific hosts only >
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP
addresses of the servers to install Agent, and the loop-back address (127.0.0.1).