NEC N8800-103F, User Manual

Page: 38 / 136

3-6 Installing Server
●
Checking the place to install
Decide the place (height) to install. To keep
balance, install it as low as you can on the rack.
To install the rack, the height for 4U is required.
IMPORTANT:
4U (the height
for installing this
device) Imprinted mark (2
imprinted marks for
5Us)
Places to install
core nuts
Imprinted mark
To install this device to the rack, the space for 1U is required for installing the USB
compatible floppy disk drive, in addition to the space for 4U.
Next to the square hole of the rack, an imprinted mark is placed for 1U (This is the unit to show the
height of the rack). This device is as high as 4U (about 176 mm), so install it between the imprinted
marks that indicate the height of 4U.
●
Installing this device
Follow the steps below to set the 4U chassis to the rack.
Front side of 4U chassis Rear side of 4U chassis
IMPORTANT:
4U chassis weighs about 10 Kg. To mount, remove or replace it, be sure to hold it with two
or more people.
The following are the required accessories. Make sure you have them all.
- Bracket -2
- Panhead screw -4
- Panhead screw with washer -4
- Plate screw (short) -8
- Plate screw (long) -4
- Washer for plate screw -12