NEC N8800-096F, User Manual

Page: 355 / 427

7-28 Troubleshooting
Command prompt cannot be display full screen:
In NEC Express5800/ft series
,
you cannot switch command prompt to full screen
mode. Also, you cannot execute applications that use command prompt full screen
mode. When you attempt to switch to full screen mode, the message below may
appear. Click [OK] and close the window.
<Example message>
Screen display size and actual drawing range do not match:
This may occur when you use application that can change resolution. Close the
application. If the screen condition does not change even after closing the application,
go to [Display Properties] - [Settings] tab - [Screen resolution] and reset the
resolution. You must reboot the system for new settings to take effect.
Exclamation mark “!” appears to “VGA Display Controller” under the “non-Plug and
Play device” when changed the setting to show hidden devices in menu in the
Device Manager:
This has to do with the server specification and there is no effect to the operation.
Exclamation mark “!” appears to “VGA Display Controller” since OS Standard VGA
driver is not activated in the server.
Exclamation mark “!” appears to “Serial” under the “non-Plug and Play device”
when changed the setting to display a non-display device in the menu by using
Device Manager:
There is no serial port that is a legacy device in NEC Express5800/ft series. When
you install Windows to a legacy-free server like NEC Express5800/ft series,
exclamation mark “!” may appears to “Serial.” This has to do with the OS
specification and there is no effect to the operation of the server.
Warning message appears in POST after implementing ft Remote Management Card:
†
Did you set “Initialize Remote Management Card”?
H/W Configuration of BMC is corrupted.
!! Update BMC H/W Configuration by configuration tool!!
!! Refer to BMC Configuration manual !!
If the message above appears, press F1 key or wait for a while. Then POST
proceeds. Insert NEC EXPRESSBUILDER CD-ROM attached to the server to the
CD-ROM drive to start NEC EXPRESSBUILDER. Select [Tools] - [Initialize
Remote Management Card] from its main menu to write the sensor information
specific to the server to the card.