NEC N8190-157A, User Manual

Page: 49 / 74

(1) PCI Express connector
Connector to be inserted into the PCI slot of the computer.
„ This product’s PCI Express connector type is x8.
(2) Bracket
Bracket to fix this product to the extended slot of Computer.
„ When fixing this product to a PCI slot optimized for the low profile type, replace the
bracket with the attached low profile one.
(3) SFP+ Module
Module to transmit and receive Fibre Channel signals. Need to remove temporarily when exchange a
bracket or install this product into computer.
„ Don’t insert the SFP+ module of this product to the other N8190-157A or the other
Fibre Channel device.
(4) LED
Two LED give a visual indication of the operating state. 㻌
The slow blink rate is 1 Hz. the flashing state is an irregular on/off appearance reflecting program
activity.
Green LED Yellow LED State
Off Off Boot Failure (Dead Board)
Off On POST Failure (Dead Board)
Off Slow Blink Boot Failure after POST
Off Flashing POST Processing in Progress
On Off Failure While Functioning
On On Failure While Functioning
On Blink(3 beat) 8Gbps Link Rate – Normal, link up
On Blink(4 beat) 16Gbps Link Rate – Normal, link up
Slow Blink Off Normal – Link Down
„ If the product fails at POST, please check the following items.
- Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
(5) Fibre Channel Connector
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(6) WWPN Address
WWPN (Worldwide Port name) Address is displayed by this label.
„ The WWPN address may be required to use an additional function of Fibre
Channel device.
(7)IEEE Address
IEEE Address is displayed by this label.
„ The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN)
address.
䣖䣫䣲䣵
䣖䣫䣲䣵
䣖䣫䣲䣵
䣖䣫䣲䣵
䣐䣱䣶䣫䣥䣧
䣐䣱䣶䣫䣥䣧