NEC MT2200, User Manual

Page: 59 / 192

4-5
Configuring Your System
Table 4-2. Resource Configuration Utility Menu
MENU OPTIONS DESCRIPTION
Step 1. Important Resource
configuration
information. Provides information on the Resource Configuration
program and how it differs from ISA board configuration.
Step 2. Add or remove boards Lists automatically detected boards, and enables manually
adding, moving and removing boards. Plug-and-Play
boards don’t require configuration files. This list shows all
the boards and options that will be installed in your system.
Step 3. View or Edit Details Enables viewing and changing your system configuration
settings including embedded features, functionality, IRQs,
and port selections. Perform Step 3 only if you need to
change the system default settings.
Step 4. Examine Switches or
Print Report Enables viewing the required switch and jumper settings
and allows printing of a configuration report.
Step 5. Save and Exit Allows you to save your configuration and exits to the
operating system. You can also exit without saving.
10. Select Step 3 to view your systems configuration
settings. The normal (default) RCU settings are
shown in Table 4-3.
RCU Command Line Parameters
There are RCU options that can be enabled by starting
the RCU from the command line with the appropriate
switch listed below. To enable an option, insert the RCU
diskette in drive A and type
A:SD
at the MS-DOS
prompt, followed by one of these command line
parameters:
H High resolution display. Sets the display mode to 43 lines
for an EGA add-in video controller board or to 50 lines for
a VGA board. The default is 25 lines for all add-in video
controller boards.
M
Monochrome display. The display screens are shown using
monochrome attributes, even on a color display. The
default is to display color, unless a monochrome video
display is detected. Use this parameter when you have
redirected the console to one of the onboard serial ports.