3. Installing Windows Server 2019
Installation Guide (Windows Server 2019)
59
Chapter 1 Installing Windows
3. On
the
Advanced
tab, set the
Speed & Duplex
values to the same as those of the switching hub.
Tips
When using the N8104-177/183/187/207/210/211,
Link control
set to
Driver
controlled
. *When
Link control
is
Preboot controlled
, link speed setting of
BIOS take a priority.
4. Click
OK
in the
Network Adapter Properties
dialog box.
5.
Restart the system.
The link speed setting is now complete.
(2)
Configuring Flow Control
Flow Control is a feature to stop transmitting frames temporarily by sending a pause frame to the destination
device when the receive buffer is about to run out. When it receives a pause frame, it regulates the
transmission. Configure the Flow Control following the procedure below
Tips
The settings of Flow Control of the network adapter should match those of the
destination device. For example, if Flow Control in the destination device is set as
Enabled, that in the network adapter should be set as Enabled.
The default value of Flow Control is may become disabled, so if Flow Control in
the destination device is set as Enabled, enable the network adapter.
1. Open
the
Device Manager
.
2. Expand
Network Adapters
, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. Open
Advanced
tab, click
Flow Control
to show Value.
4.
The Value can be changed by the down-arrow button.
5. Click
OK
, and then restart the system.
The Flow Control setting is now complete.
Tips
For N8104-208/212, it is recommended to set the
Receive Buffer
value to
4096
.
(3)
Setting up Wake on LAN
-
When using R120h-1E / R120h-2E / T120h standard network adapters and N8104-172/175/193/194/
195/206/208 with the server, follow the procedure below to set it.
1. Open
the
Device Manager
.
2. Expand
Network Adapters
, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. Open
Advanced
tab, click
Enable PME
to show Value.
4.
Change the value to
Enabled
by the down-arrow button.
5. Click
OK
, and then restart the system.
Setup is now complete.
