3. Installing Windows Server 2019
Installation Guide (Windows Server 2019)
58
Chapter 1 Installing Windows
N8104-211
Marvell FastLinQ Ethernet 10/25Gb 2-port SFP28 QL41232HLCU Adapter #xx(
*
1)
N8104-212
Intel(R) Ethernet Network Adapter E810-XXV-2 #xx(
*
1)
N8104-213
HPE Ethernet 10Gb 2-port 535FLR-T Adapter #xx(
*
1)
N8104-215 HPE
Ethernet
10Gb
2-port 535T Adapter #xx(
*
1)
N8104-217
Broadcom NetXtreme E-Series Dual-port 10GBASE-T Ethernet OCP 3.0 Adapter #xx(
*
1)
N8104-219
Broadcom P210tep NetXtreme-E Dual-port 10GBASE-T Ethernet PCIe Adapter #xx(
*
1)
*1: If there are adapters with the same name, a different identification number will be assigned to
xx
.
Tips
The ID for N8104-173/177/182/183/185/187/207/210/211 might be a number of
two or more digits. This is due to the LAN driver specifications and not an error.
This number cannot be changed.
Tips
The network adapter name displayed in the device manager may be different from
the one listed above.
In this case, the correct network adapter name can be displayed by following the
procedure below.
1. Start
Device Manager
.
2. Open
Network Adapters
, right click on the relevant adapter, and select
Uninstall Device
.
3. When
Delete the driver software of this device
checkbox is displayed,
do not surely put a check.
4. Select
Uninstall
.
5. Select
Scan hardware change
from
Control
.
3.6.2
Setting up LAN drivers
(1)
Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
Important If you are using a network adapter for N8104-213/215/217/219, changing the
setting is not supported of "Speed & Duplex".
Use int the "Auto Negotiation" of default value.
Tips
If you are using a network adapter for N8104-177/185/187, the network adapter
settings can be set to "10 Gbps Full Duplex" or "25 Gbps Full Duplex", and the
connected switching hub settings can be set to "Auto Negotiation".
1. Open
the
Device Manager
.
2. Expand
Network Adapters
, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
