3. EXPRESSSCOPE ENGINE 3
Express5800/B120e-h User's Guide
96
Chapter 3 Setup
3.2
EXPRESSSCOPE ENGINE 3 Network Configuration
The network configuration of management LAN of EXPRESSSCOPE Engine 3 is obtained automatically from
the Enclosure Manager which has DHCP server function. For detailed information on DHCP server of EM card,
refer to
EM Card User's Guide
or
Blade Enclosure User's Guide
. By the factory default,
DHCP
is set to
Enabled
.
If
DHCP
is set to
Disabled
and you want to use the management LAN of EXPRESSSCOPE Engine 3, follow
steps below to configure the network.
1.
Run POST following
Chapter 3 (1.5.1 POST Execution Flow)
. Wait until the following message
appears on the lower left of the screen.
Press <F2> SETUP, <F3> Internal flash memory, <F4> ROM Utility, <F12> Network
2.
If you press the <F4> key at this time, ROM utility starts upon completion of POST.
You can also press the <F4> key while the NEC logo is being displayed to open the Off-line TOOL
MENU screen.
3.
The keyboard selection screen appears. Select your keyboard type.
After that, the Off-line TOOL MENU screen appears. On this screen, specify the network settings for
EXPRESSSCOPE Engine 3.
