4. Names and Features of Component
Express5800/B120e-h User's Guide
31
Chapter 1 General Description
CPU Blade Access Side
1
DMP
RST
2
ID
(1) POWER
lamp
The lamp goes on green when the CPU blade is
powered on.
The lamp goes on amber when the CPU blade is
powered off but the power is supplied from the
power supply unit.
(2) POWER
switch
The switch is intended to turn on or off the power
of the CPU blade itself. Pressing the switch for 4
seconds or longer causes the power supply to be
turned off forcibly.
(3) STATUS lamp (green/amber/red)
The lamp indicates the status of the CPU blade.
See "Lamp Indications" described later for the
indications and meanings of the lamp.
(4) DUMP
switch
Press this switch to run the memory dump.
(5) LAN1 Link/Access lamp (green)
The lamp goes on when LAN port 1 is connected
to the network. The lamp blinks when data is
being transmitted.
(6) RESET
switch
Press this switch to reset the CPU blade.
(7) LAN2 Link/Access lamp (green)
The lamp lights when LAN port 2 is connected to
the network. The lamp blinks when data is being
transmitted.
(8) ID/BMC
RESET
switch
Press this switch to turn on or off the ID lamp.
Pressing this switch toggles lamp ON/OFF.
Refer to
Chapter 1 (7.2 BMC Reset)
in
Maintenance Guide
for BMC RESET switch.
(9) ID
lamp
The lamp is intended to identify the CPU blade in the
system. The lamp is lit by a switch or software command.
When the recognize command is received from NEC
ESMPRO Manager and when the ID switch is pressed, the
lamp goes on.
You may use the remote control feature of
EXPRESSSCOPE Engine 3 (BMC) to perform the same
operation as using the ID switch on the server.
(10) Eject lever
Pull the lever to remove the CPU blade from the Blade
Enclosure.
(11) SUV cable connector
This connector sends or receives various signals.
The K410-150(00) SUV cable (separately-priced or
provided with the SIGMABLADE) is connected to this
connector.
(12) SSD Access lamp
If the server is equipped with optional Solid State Drives,
the lamp goes on while optional Solid State Drive is being
accessded. (upper: #0 / lower: #1)
(13) Slide tag
A label on which the model number and serial number are
described is attached this slide tag. You can check the
label contents by pulling this slide tag.
1
DMP
RST
2
ID
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(10)
(13)
(13)
(12)
