NEC Express5800/180Rb-7, User Manual

Page: 104 / 196

3-46 Configuring Your System
OM08749
ON
OFF
SW4G1
Figure 3-6. Location of the System Configuration Switches
Clearing CMOS
To clear CMOS:
1.
Ensure that the system is powered off. Remove the PCI hot-plug cover. On
switch SW4G1 (see Figure 3-5 and Figure 3-6), slide or press switch number
5 to the right most position.
2. Power on the system. Wait for POST to complete and for the messages
“NVRAM cleared by jumper” and “Press F2 to enter Setup” to appear. This
automatically reprograms CMOS to the default settings, except for the
password.
3. Enter Setup and make any changes necessary (for example, changing the
boot device). Press F10 to save the new Setup configuration and exit Setup.
4.
Power off the system.
5.
Return switch number 5 to the left most (default) position.
6. Reinstall the PCI hot-plug cover using the original screws, power on the
system, and resume normal operation.
7.
Run the BIOS Setup Utility as described earlier in this chapter to verify the
correct settings.