4-30
Upgrading Your System
3.
Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
4.
Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
Note:
If the drive comes with drive rails, do not use
them. Remove any rails already attached.
5.
Slide the drive into the bay until the screw holes line up. It may be necessary
to temporarily loosen the mounting screws on the already installed drives to
position the new drive. Secure the drive to the bay with the four supplied
screws. See Figure 4-29.
5.25" Drive
Power Cable
Figure 4-29. Installing a Removable Media Device
6.
Connect the signal and power cables to the device as shown in Figure 4-21.
7.
Replace the front panel and side panels, and power on the system.
Summary of Contents for EXPRESS5800/120Ed
