NEC Express 5800/140Rb-4, Service Manual

Page: 133 / 145

Beep codes
If an error occurs during the POST, the server beeps, indicating the type of error.
Each number indicates the number of short beeps, and a hyphen indicates a pause. For
example, the beep interval 1-2-2-3 indicates 1 beep, pause, 2 beeps, pause, 2 beeps, pause,
and 3 beeps notifying that the checksum error occurred on ROM.
Table Post Error Beep Codes
Beeps
Error Recommended Action
1-2-2-3 ROM Checksum Error Power cycle the server. If the same error still occurs, call your
service representative.
1-3-1-1 DRAM Refresh Test Error Check if memory board and memory DIMMs are installed
correctly. If the same error still occurs, call your service
representative.
1-3-1-3 Keyboard Controller Error Check keyboard connections. If the same error still occurs, call
your service representative.
1-3-3-1 Memory Not Detected or
Incorrect DIMM Type
Check if memory board and DIMMs are installed correctly.
Change memory DIMM's. If the same error still occurs, call your
service representative.
1-3-4-3 All Memory Group Errors Check if memory board and DIMMs are installed correctly. If the
same error still occurs, call your service representative.
2-2-3-1 Illegal Interrupt Test Error Check system board. If the same error still occurs, call your
service representative.
1-2 Video BIOS Initialization
Error Check display monitor connections and also power cycle the
server. If the same error still occurs, call your service
representative.
1-2 Option ROM Initialization
Error Check ROM BIOS setting in BIOS Setup. Reinstall the PCI
board. Check system board. If the same error still occurs, call
your service representative.