NEC 1260 - SuperScript - Printer, User Manual

Page: 28 / 168

2-4 NEC SuperScript 1260 User’s Guide
Chapter 2 : Operator Panel
Table 2-1: Condition Indications and Solutions
LEDs CONDITION CAUSE/SOLUTION
All lit steady Printer Hardware
Error A printer hardware error is detected. Possible printer errors include
malfunction of the fuser unit, laser unit, scanning motor, or fan.
Corrective Action: First power off the printer and then turn power
back on. If the problem continues, contact your NEC dealer for
service or call NEC technical support (see Chapter 10).
All lit steady
except On Line NIC (Network
Interface Card) Error Corrective Action: Press the Test button on the Operator panel to
verify communication. Refer to “SuperScript 1260 Network Printer
Configuration Guide”.
All lit then cycle
all LEDs Power On When you power on the printer, all the LEDs light and then, during
hardware check, cycle through all LEDs (starting from On Line LED
and moving right), and then the green light blinks until the printer is
ready to accept a job during the Power On cycle.
All lit then cycle
all LEDs Factory Default Reset During power up, press the On Line Button until lights stop cycling,
then release. After that, the green light blinks until the printer is
ready to accept a job.
Corrective Action: Release the Front Panel Button after the LEDs
light in acknowledgment. Once the button is released, the printer
sets factory defaults, initializes, and goes to READY.
Cycle through all
LEDs Reset When the On Line button is pressed for at least 4 seconds (in all
states other than during power up), it cycles through all LED’s and
then the green light blinks until the printer is ready to accept a job.
Corrective Action: Release the Front Panel Button after the LEDs
blink in acknowledgment. Once the button is released, the printer
initializes and goes to READY.