NEC 1080Xd, User Manual

Page: 91 / 216

Service Processor 3-41
Table 3-35. HC Subcommands (cont’d)
cmd arg1 arg2 arg3 arg4 Description
mmc xy
(cont’d)
cache z - - Enables the Cache.
“ z ” is the Cache number (0-7).
tag x [ sy ] - - - Enables the TAG.
“ x ” is the physical CELLV Board number (0-3).
“ s ” is either “e” (EVEN side) or “o” (ODD side).
“ y ” is the TAG number (0-3).
When “ sy ” is omitted, all the TAGs under the
CELLV Board specified by “ x ” become enabled.
pcix x all - - Enables the PCIV/PCIX Unit.
“ x ” is the DGI/I2C cable port number (0-3) of the
cable from the ISP-C Board to the PCIV/PCIX
Unit.
“all” must be specified as the second argument.
Then, not only the PCIV /PCIX Unit but also its
subcomponents become enabled.
IOR0 is installed on the XIC Board. But the
IOR0 is managed with the PCIX0(V) to realize
the same operation as the PCIX Unit.
[all] - - Enables the IOR chip.
“ x ” is the physical IOR chip number (0-3).
When the second argument is omitted, only the
IOR chip is enabled, and the states of any other
subcomponents do not change.
When “all” is specified as the second argument,
not only the IOR chip but also its
subcomponents become enabled.
nci y - - Enables the 1.6G interface part.
“ y ” is the interface number (0 only).
When the 1.6G port of IOR chip is enabled,
corresponding 1.6G port in the XBC chip/NC
chip is also enabled (and vice versa).
enable
(cont’d)
ior x
ioc y - - Enables the IOC.
“ y ” is the IOC number (0 or 1) within the IOR
Daughter Board.