NEC 1080Xd, User Manual

Page: 30 / 216

2-2 System Operation
Setting Up the Server
Use the following procedure to set up the server.
Note:
See Chapter 1 of this user’s guide to become
familiar with server features, such as the location of system
switches, indicators, and main chassis components.
1.
Check that the server has been installed as described in the
Express5800/1080Xd/1160Xd/1320Xd Site Preparation Guide and
Express5800/1080Xd Installation Procedures . This server requires
installation by qualified personnel such as an NEC technician and system
administrator.
2.
Make sure that any optional components other than I/O cards or boards,
have been installed by an NEC technician.
If you have an I/O card or board to install, install it now (see Chapter 5, “I/O
Board Installation”).
3. Unlock the rear door of the server with the security key. Open the door by
lifting the handle and turning it clockwise (see Figure 2-1).
Server cable connectors for system setup are located at the rear of the server.
A Lift Handle
B Turn Clockwise
Figure 2-1. Opening the Rear Server Door
A
B