Chapter 2: Setting Up and Using the Printer
7156 Owner’s Guide
September 1997
24
Testing the Printer
Test the receipt station using the simple tests described in this section. To further test the
receipt station or to test the slip station, run the level 1 diagnostic tests described in “Level
1 Diagnostics” in “Chapter 4: Diagnostics.” See “Chapter 3: Solving Problems” for what to
do if the printer is not functioning properly.
The tests print data about the printer’s configuration which is useful to a service
representative if there is a problem. The settings for the various functions which control the
configuration are in “Level 1 Diagnostics” in “Chapter 4: Diagnostics.”
The tests also print all variations of the character sets with a partial cut between each
variation. See the sample on the facing page. The tests end with a partial cut, then begin
again. Several feet of paper can be used to print one pass of the test.
Running the Print Test by Power Cycling the Printer
1. Press the On Line button (or plunger) to put the printer off-line.
Use a paper clip or other pointed object to depress the plunger on models with that
item. The On Line light (green) goes off.
2. Press and hold down the Paper Feed button, then press the On Line button (or
plunger) to begin the test.
3. Let go of the Paper Feed button once the printing begins.
The printer prints the data and character sets until you stop it (see the sample).
4. To stop the test, press the Paper Feed button.
The printer is ready to receive and print data from the host computer.
Running the Print Test by Opening and Closing the Cover
1. Press the On Line button (or plunger) to put the printer off-line.
Use a paper clip or other pointed object to depress the plunger on models with that
item. The On Line light (green) goes off.
2. Open the receipt cover by pulling up on the front left side of the cover.
The Paper Status light (red) comes on indicating the receipt cover is open and that the
printer cannot receive or print data (not that the paper is out).
3. Press and hold down the Paper Feed button while closing the receipt cover.
4. Let go of the Paper Feed button once the printing begins.
The printer prints the data and character sets until you stop it (see the sample).
5. To stop the test, press the Paper Feed button.
The printer is ready to receive and print data from the host computer.
Summary of Contents for 7156
