7156 Owner’s Guide
Chapter 6: Commands
September 1997
63
Open Form (Slip Station)
Opens the feed roller and platen (forms compensation arm assembly) so that a form may
be inserted (default position).
Hex
Decim
al
ASCII
18
24
CAN
Full Knife Cut
This command is implemented the same as Partial Knife Cut (1A, 1B 6D). Use either
Hex 19 or Hex 1B 69.
Hex
Decima
l
ASCII
19
1B 69
25
27 105
EM
ESC i
Partial Knife Cut
Partially cuts the receipt. The length of the cut can be changed through the DIP switches.
See “Setting Partial Cut Distance” in “Chapter 4: Diagnostics.” The default setting leaves
.20 inches (5 mm) of paper on the left edge. The cut edge is 108 dot rows or .71 inches (18
mm) above the receipt print line. The command is valid only at the beginning of a line.
Use either Hex 1A or Hex 1B 6D.
Hex
Decima
l
ASCII
1A
1B 6D
26
27 109
SUB
ESC m
Generate Tone
Activates a short tone.
Hex
Decim
al
ASCII
1B 07
27 7
ESC BEL
Set Column
Prints the first character of the next print line in column n. The command is not valid with
Single or Double Density graphics.
Hex
Decimal
ASCII
Value of
n
Receipt (Pitch)
Value of
n
Slip (Pitch)
1B 14 n
27 20 n
ESC DC4 n
1-44 (Standard)
1-66 (Standard)
Summary of Contents for 7156
