8
CHARGING THE BATTERY
Turn the camera o
ff
and connect the USB cable to the camera and to your power source (i.e. in-car charger,
PC USB port or USB Mains Power Adaptor) The charging indicator light will turn RED. When the ba
�
ery
charge is full, the light will turn OFF. A typical full charge takes up to 4 hours.
NOTE: The ba
�
ery does not need to be removed under normal usage and charging condi
�
ons. If
removed, please note the polarity of the ba
�
ery when re-inser
�
ng. Take note of the input voltage and
current required by this device when connec
�
ng an external charger.
WATERPROOF CASE
1. Use your
fi
nger
�
p to gently pull the release lock and clamp, in the direc
�
on of the arrow (on the
clamp)
2. Inspect the white rubber water seal gasket to ensure it is in good condi
�
on, and then insert the camera
in the correct orienta
�
on.
Note 1: You can test the gasket by closing the case without the camera inside and submersing it completely
in a bowl of water for a few minutes. Remove the case from the water, dry off the exterior with a towel, and
then open the case carefully. If the interior is dry, the camera and case will be safe for use under water.
Note 2: Only two buttons are required for recording video and images: the Shutter Button, and the On/Off
button.
Note 3: Remember, when the unit is turned OFF and ON again, the unit will default to VIDEO modes and
the default resolu
�
ons.
Release clamp
On/O
ff
Bu
�
on
Case Hinge
Shu
�
er Bu
�
on
