Navico 2kW, Installation Manual

Page: 69 / 80

Troubleshoot the radar | 67
This appendix gives information on fixing possible problems with the radar. Many problems are
caused by:
•
faulty or loose contacts at switches and relay points
•
poor adjustment of the radar (particularly inadequate tuning adjustment)
•
poor maintenance (particularly of the cables)
You'll save yourself a considerable amount of time if you check these items before placing a call
to Navico; plus, you may find the problem right away.
10.1 Technical support, service and repairs
The product is covered by a warranty which is supplied as a separate document.
If you need technical support or answers to other questions after you've followed the
instructions in this manual, you can:
•
contact your Navico distributor or
•
see the inside back cover of the manual or
•
visit www.navico.com
Before you make contact, be sure to have:
•
the serial number of the hardware (usually shown on the faceplate of the unit).
When you describe the problem, be as complete and as accurate as possible.
10.2 Radar is not operating correctly
If no image appears on the screen and screen shows message no scanner detected:
•
check radar scanner interconnect cable wiring.
If no image appears on the screen and the screen shows message no radar detected:
•
check the data cable between the radar and the display head system
•
check that the radar processor has power
If the scanner is working but no image appears on the display:
•
adjust gain and threshold
If the display shows only noise:
•
check that the scanner and open array (if applicable) are fitted correctly
If radar reception is poor:
•
check for physical damage to the cables (such as fraying) and for any loose connections
•
check for water damage to the radiator or to the cables between the radar components
•
check for interruptions in the pulse switching signal
If an image appears on the display but the direction of the radar image is not stable:
•
the direction standard signal (BZ) is being interrupted (see the Service Manual)
•
check for water damage to the radiator or cables between the radar components.
10.3 If the scanner fails to turn
If the scanner fails to turn, it is possible that there has been a breakdown of either the motor
unit inside the scanner or the safety switch of the scanner unit.
Turn the power OFF and investigate as follows:
•
Visually check for, and remove, any external obstruction.
•
Open the scanner dome or gearbox and perform an internal inspection.
10 Troubleshoot the radar