Navico 2kW, Installation Manual

Page: 46 / 80

44 | Connect Northstar 6000i / 6100i
7.3 Connect the radar communications cable (NS003107) to the
junction box
The radar communications cable (NS003107) splits the 14 pin connector of the 6000i/6100i into
(three) 3 different connectors, Bare Wires, Radar Comms and SmartCraft. This cable allows the
6000i/6100i to connect to NMEA devices (Bare Ends) or to Navico digital radar (Connector 1) or
to a SmartCraft junction box (connector 2).
The output of the internal wires of the cable are in some cases duplicated, for example, pin 6
on the connector ends the white/brown bare end and the pin 1 of the radar comms connector. It
is critical that the connector pins sharing multiple outputs such as pin 6 not be connected at the
same time to different devices. i.e. If you are connecting a 6000i/6100i to the Navico radar
processor box you must not connect any other device to the bare ends White/Brown,
Brown/White, Yellow, Orange, Black, Orange/White and Drain.
The free ends of the radar communications cable (NS003107) must be terminated in a junction
box or isolated from each other (see the figure in the previous section). The junction box is not
supplied.
The communications cable has a 0.41" (10.5 mm) diameter. The junction box must be
waterproof and large enough to contain a 20 way strip connector.
All cable entry points should use suitable grommets or glands to ensure that waterproofing is
maintained.
The table shows the wiring and pin details of the radar communications cable. The naming
convention for the bi-colored wires is primary color/stripe; for example, White/Orange refers to
a white colored wire with an orange stripe.
* DO NOT connect the bare wires if the radar comms (connector 1) is connected to the
radar processor box
**DO NOT connect these bare wires if the SmartCraft (connector 2) is connected to
the SmartCraft gateway
NMEA devices must be connected to an unused NMEA port on the connector strip.
The remote power signal configuration is explained in "Configure the remote power control for a
6000i or 6100i (common power source)" and "Configure the remote power control for a 6000i or
6100i (different power sources)".
Wire function 6000i/6100i
connector PIN
Bare wires Radar comms
(connector 1)
SmartCraft
(connector 2)
PI
N
Color Color Pin Color Pin Color
NMEA 1 IN A 3 Brown Brown
NMEA 1 IN B 1 Blue Blue
NMEA 1 IN GROUND 4 White/Blue White/Blue
NMEA 1 OUT A 12 Violet Violet
NMEA 1 OUT B 7 Gray Gray
NMEA 1 OUT
GROUND 8 Blue/White Blue/White
NMEA 2 IN A 6 White/Brown White/Brown * 1 Green
NMEA 2 IN B 2 Brown/White Brown/White * 2 Red
NMEA 2 IN GROUND 5 White White *
NMEA 2 OUT A 15 Yellow Yellow * 7 Orange
NMEA 2 OUT B 11 Orange Orange * 8 Blue