Assembly / Owner’s Manual
9
2. Install the Handlebar to the Handlebar Post
NOTICE:
Remove the AC Adapter from the Handlebar. The hardware (
*
) is pre-installed.
After installation, make sure the hardware is fully tightened.
3. Attach the Handlebar Assembly and Seat Stem to the Frame Assembly
Do not set the Seat Stem or Handlebar Post position higher than the stop mark (STOP) on the tube.
NOTICE:
Make sure the Handlebar Post Adjustment Handle is fully tightened to secure it on the Handlebar Post, and the Seat Stem Adjustment
Handle is fully tightened to secure it on the Seat Stem. When fully tightened, the Adjustment Handles must point downward.
Note:
To adjust the height after the handle is tightened, loosen the handle as you hold the upright post to prevent it from dropping. Move it to the desired
position and tighten the handle. Pull the handle out to disengage and turn so that it points down, then release.
*
*
X4
5
4
17mm
9
9
6
Summary of Contents for Bowflex VeloCore
Page 36: ...8025856 050120 A EN ...