![background image](http://html.mh-extra.com/html/nautilus/be-strong-commercial-r916/be-strong-commercial-r916_service-manual_711571044.webp)
44
Mechanical Procedures
Step 3:
Disconnect the cable end of the Speed Sensor from
J2 on the Power board and remove the wire from the
bundle. See
Figure 21
.
Step 4:
Loosen the adjustment screw and remove the Speed
Sensor from the Alternator (
Figure 22
).
Note:
Early model Speed Sensors are tightened with
a screw adjustment. Later models are tightened
with a nut and bolt.
When you (re)place the sensor on the Alterna-
tor, be sure the gap between the fan blade and
the Sensor is .020 - .040.
REMOVING THE ALTERNATOR:
Tools needed:
Phillips screwdriver or Cordless drill with Phillips tip
Wire cutters
Impact cordless wrench
15/16” socket and ratchet
6mm Allen wrench
8mm Allen wrench
9/16” socket
Step 1:
Remove the right and left side covers according to the
appropriate REMOVING THE SIDE COVERS procedure
(U916 or R916).
Step 2:
Remove all the attached cables from the Alternator,
then detach the Speed Sensor from the Power board.
See
Figure 23
.
Note:
Make note of where and how the cables are
attached to the Alternator.
figure 21 - Disconnect speed sensor cable
figure 22 - Loosen adjustment screw
figure 23 - Detach all cables from alternator
figure 24 - Remove flywheel
Summary of Contents for Be Strong Commercial R916
