4
Nautilus® Commerical Series Bike Service Manual
Mechanical Procedures
figure 38 -
figure 39 -
figure 40 -
Step 3:
Disconnect the cable wire connected to the PC board
from the front plate. See
Figure 38
.
Step 4:
Disconnect the red CHR wire from the front plate and
place to the side. See
Figure 39
.
Step 5:
Reverse the steps when reinstalling the plates.
Note:
Be careful not to pinch the cable wires when
reattaching the Front and Rear housings.
REPLACING THE LOWER T-BAR RIGHT OR LEFT CHR PLATES:
Tools needed:
#0 Phillips screwdriver
Step 1:
Carefully remove the two screws from the rear CHR
plate and separate the plates. See
Figure 40
.
Step 2:
Disconnect the black CHR wire from the rear plate and
place to the side.
Step 3:
Disconnect the red CHR wire from the top plate and
place to the side.
Step 4:
Reverse the steps when reinstalling the plates.
Note:
Be careful not to pinch the cable wires when
reattaching the Front and Rear housings.
Summary of Contents for Be Strong Commercial R916
