44
© 2011
Nautilus Hyosung, Inc.
All Rights Reserved.
CLEANING METHOD
In order to prevent the problems caused by sensor pollution, the Sensor Cleaning should be
done properly. The cycle of the cleaning varies depending on the function, location, and
degree of pollution of the component. For the execution of the cleaning process described
below, thorough management and implementation is required, followed by the assessment of
the results later on.
NO.
LOCATION
INT.
REMARK
1
Sub Module
/Sensor
Rollers
M3
Remove
debris
and
dusts using soft brush,
air blower and air can
2
Prism
M3
3
Sensors
M6
※
M3 : Once every 3 months M6 : Once every 6 months
NOTE: Be sure to check whether each sensor operates normally on TM after cleaning
CCIM Sensor.
Summary of Contents for MX7700QT
