2.
For Windows users: Open the KOMPLETE AUDIO 6's Control Panel software. In the Control
Panel, go to the
Audio Settings
page and set the
Digital Sync Source
to the
External S/
PDIF 5|6
setting. The KOMPLETE AUDIO 6 checks for availability of external syncing
sources. If the synchronization request fails, the interface switches back to internal clock
mode. If synchronization is possible the top panel’s Sync LED lights orange (see also
chapter
).
3.
For Mac OS X users: Go to
Applications > Utilities > Audio and MIDI Setup
to open the
Audio and MIDI Setup utility. From the
Clock source
drop-down menu select
External
Clock (S/PDIF)
. The KOMPLETE AUDIO 6 checks for availability of external syncing sour-
ces. If the synchronization request fails, the interface switches back to internal clock
mode. If synchronization is possible the top panel’s Sync LED lights orange (see also
chapter
).
6.6
Direct Monitoring
In the
Monitor
section of the KOMPLETE AUDIO 6 audio interface, you can set the device to
bypass any signal processing and send the audio signal from the input directly to the output of
the device at zero latency. This function is known as Direct Monitoring.
The Direct Monitoring feature only applies to inputs
IN 1/2
and is not available for in-
puts
IN 3/4
and
IN 5/6
.
You can activate Direct Monitoring via the
ON
switch in the
Monitor
section, which is located
on the front panel of the KOMPLETE AUDIO 6. This routes the signal of the inputs
IN 1
and
IN 2
directly to the selected outputs. The
ON
switch also doubles as an output
MONITOR
se-
lector switch. When held for one second, it cycles through three monitoring modes:
▪
Monitor signal to outputs
OUT 1/2
▪
Monitor signal to outputs
OUT 3/4
▪
Monitor signal to both output pairs
OUT 1/2
and
OUT ¾
The LEDs on the device's top panel display which monitoring mode is active.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
Direct Monitoring
KOMPLETE AUDIO 6 - Manual - 49
Summary of Contents for Komplete Audio 6
Page 1: ...MANUAL ...
