Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter
2, Installing KOMPLETE AUDIO 6
), and configured as your com-
puter's main audio output device (see chapter
). See chapter
for instructions on how to connect speakers (active and passive) to your
KOMPLETE AUDIO 6.
To use the KOMPLETE AUDIO 6 in a setup with typical line level equipment:
1.
Turn the Volume Control knob (
MAIN VOLUME 1/2
) on the top panel of the KOMPLETE
AUDIO 6 to the left-end stop to set the volume to minimum.
2.
Plug a pair of stereo 1/4" TRS cables from the outputs of your device into the inputs
IN 3
and
IN 4
on the rear panel of the KOMPLETE AUDIO 6 or unbalanced ¼” cable if you are
using a mono device.
3.
Open the audio preferences of your audio recording software, and select the KOMPLETE
AUDIO 6 as your input and output device (you may have to restart your host software for
the changes to become active). Refer to the documentation of your audio recording soft-
ware for information on how to configure the audio device setup.
4.
Adjust the output signal of your connected device by using the relevant volume/gain con-
trol. Check the KOMPLETE AUDIO 6's input LEDs (
INPUT 3
and
4
on the top panel) to
make sure your input signal does not clip; adjust the device’s output level so that the
LEDs light green on input. A red lighting LED indicates signal clipping.
5.
Gradually turn the Volume Control knob (
MAIN VOLUME 1/2
) on top of the KOMPLETE
AUDIO 6 to the right until you reach a good listening level.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
KOMPLETE AUDIO 6 - Manual - 44
Summary of Contents for Komplete Audio 6
Page 1: ...MANUAL ...
