©
National Instruments Corporation
Index-1
VXIpc 800/700 Series User Manual
Index
A
ACCESS LED, 1-8, D-3
adding RAM, A-6
address map, I/O. See I/O address map.
audio capability. See speaker.
B
BIOS. See also CMOS.
clearing CMOS contents
VXIpc 700 Series, 4-7
VXIpc 800 Series, 3-11
entering setup, 5-1
viewing settings, G-4
block diagrams
VXIpc 700 Series, 2-3
VXIpc 800 Series, 2-2
board access LEDs, D-3
bulletin board support, H-1
C
CLK10 signal, VXIbus
accuracy, G-1
definition, G-1
routing, 3-5 to 3-7
selecting signal source (figure), 3-6
SMB CLK10 direction (figure), 3-6
SMB CLK10 polarity (figure), 3-7
SMB CLK10 termination (figure), 3-7
CMOS. See also BIOS.
PC configuration
VXIpc 700 Series, 4-7 to 4-8
VXIpc 800 Series, 3-10 to 3-13
setting back to default, G-4
COM1 and COM2 connectors and signals,
E-9 to E-10
common questions about VXIpc 800/700
Series, G-1 to G-4
configuration, VXIpc 700 Series
default settings, 4-1 to 4-3
factory default settings (table), 4-3
parts locator diagram, 4-2
EEPROM, 4-5 to 4-7
configuration settings (figure), 4-6
fixing invalid configuration, 4-6 to 4-7
power-on self configuration status
(figure), 4-5
protecting against electrical hazards
(warning), 4-6
electrostatic discharge (warning), 4-1
installed system RAM, 4-7
installing VXIpc-700 Series, 4-8 to 4-9
PC configuration, 4-7 to 4-8
Ethernet power-on defaults, 4-8
system CMOS, 4-7 to 4-8
removing metal enclosure, 4-3
trigger input termination, 4-5
SMB trigger input termination
(figure), 4-5
VXIbus Slot 0/non-Slot 0, 4-4
configuration, VXIpc 800 Series
default settings, 3-1 to 3-3
factory default settings (table), 3-3
parts locator diagram, 3-2
EEPROM, 3-8 to 3-9
configuration settings (figure), 3-9
