Page 1 of 2
Lapbank Mini Cable Installation
Applicable Models
6026 Lapbank 16 mini
6028 Lapbank 20 mini
6029 Lapbank 24 mini
6027 Lapbank 32 mini
1.
2.
3.
1. The power arrangement is ready for the transformer to be plugged into the power distribution strip. The power
supply cables can be seen sitting in the rear of the trolley, ready for connecting to the wall socket.
2. The excess power supply lead is neatly coiled and secured within the side recess using the cable ties provided.
3
.
This photo from inside the cabinet shows the transformer attached to the shelf using the industrial Velcro provided.
The power supply cable can be seen plugged into the rear of the transformer after entering through the plastic
grommet. The low voltage cable is seen coiled and secured to the inside wall leaving only the length required to make
an easy connection. Ensure that the excess cable is not able to fall over the front of the shelf and become trapped.
Repeat process on each power bar, leaving 2 laptops on each shelf.
NB. The mini 32 has a fully closing door to the rear of the cabinet, and is configured in exactly the same way as the
other mini trolleys.
Hints for easy installation.
a) Separate the transformer from the power lead
b) Attach the self-adhesive Velcro to the underside of the transformer.
c) Engage a second piece of Velcro onto the above Velcro – do not remove paper.
d) Thread the power connector through the gromet from the outside and re-connect to the transformer.
e) Remove the paper back of the Velcro and stick transformer to the shelf as close to the side and as far back as
convenient. See photo above.
f) Coil excess low voltage cable and secure to the inside wall of the cabinet using cable ties provided.
g) Repeat this process for all shelves on one side.
WARNING. Make sure the correct laptops are connected to the appropriate charging leads each time the
laptop is charged.
h) On the outside of the cabinet coil the excess power lead of the top compartment and loosely attach to the side of
the cabinet within the recess using a cable tie looped over the top pair of cut outs. Do not tighten the cable tie yet.
i) Engage plug in top socket.
j) Continue down the shelves using one cable tie to secure the bottom of one coil and the top of the lower coil
through one pair of cut outs.
k) Adjust coils to neat appearance, tighten ties and snip off excess cable tie being careful not damage the power
leads.
l) Repeat on the other side of the cabinet.
m) The two power cables on the top of the unit are deliberately left long for shortening by the customer if necessary.
n) If in any doubt about this operation contact a qualified electrician.
Before charging the laptops check that:
1. The wall socket is switched on
2. The green RESET button on the RCD is pushed in
3. The red neon indicator switch on the power strip is switched on and lit
4. The mains plug to the laptop transformer is plugged into the power strip
5. The figure of eight or kettle lead is plugged into the transformer
6. The low voltage power plug is pushed firmly into the laptop charging socket.
