2.
Power off the chassis.
3.
Inspect the slot pins on the chassis backplane for any bending or damage prior to
installation. Do not install a module if the backplane is damaged.
4.
To prevent damage to the chassis, ensure that you are installing the module in the correct
type of slot. Refer to the
Chassis Parts
section for the slot descriptions.
5.
Install the module into the chassis slot by first placing the module card PCB into the front
of the card guides (top and bottom), as shown in the following figure. Slide the module to
the rear of the chassis, making sure that the injector/ejector handle is pushed down.
Figure 11. Installing PXI, PXI Express, or CompactPCI Peripheral Modules
PXIe-
1092
COOLING CLEARANCE REQ
UIRED. SEE MANUAL.
3
2
1
4
5
1. Injector/Ejector Handle
2. PXI Peripheral Module
3. Peripheral Module Front Panel Mounting Screws
(2x)
4. PXIe-1092 Chassis
5. Injector/Ejector Rail
6.
When you begin to feel resistance, push up on the injector/ejector handle to seat the
module fully into the chassis frame. Secure the module front panel to the chassis using
the module front-panel mounting screws.
Installing Peripheral Modules in the Peripheral
Expansion Slot
Caution
ThePXIe-1092 chassis has been designed to accept a variety of peripheral
module types in different slots. To prevent damage to the chassis, ensure that the
peripheral module is being installed into a slot designed to accept it.
Note
The peripheral expansion slot does not provide PCI/PXI Express
communication and timing signals. The peripheral expansion slot provides power
and connector alignment to allow a multiple slot peripheral module to expand to the
right and avoid covering up a peripheral slot.
20
|
ni.com
|
PXIe-1092 User Guide
