The Power Inhibit switch allows you to power on the chassis or place it in standby mode. With
an empty chassis in Default Mode, press down the Power Inhibit switch and hold it down for
four seconds. Observe that all fans become operational and all three front panel LEDs are a
steady green. Pressing and holding the Power Inhibit switch again for four seconds will return
the chassis to standby.
Installing a System Controller
This section contains general installation instructions for installing a PXI Express system
controller in a PXIe-1092 chassis.
Note
Refer to your PXI Express system controller user manual for specific
instructions and warnings.
Caution
Be sure the chassis is connected to an AC power source before installing
the system controller. The AC power cord grounds the chassis and protects it from
electrical damage while you install the controller.
1.
Inspect the slot 1 pins on the chassis backplane for any bending or damage prior to
installation. Do not install the system controller if any pins are bent or damaged.
2.
Install the system controller into the system controller slot (slot 1, indicated by the red
card guides) by first placing the system controller PCB into the front of the card guides
(top and bottom). Slide the system controller to the rear of the chassis, making sure the
injector/ejector handle is pushed down as shown in the following figure.
18
|
ni.com
|
PXIe-1092 User Guide
