Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-15
NI-FBUS Hardware and Software User Manual
7.
Connect the primary 11–30 VDC power supply to the center V and
C pair with the positive and negative wires on your power cable in the
V and C terminals, respectively. You can connect an optional backup
power supply to the left V and C pair. The power connector is a 6-pin
screw terminal power connector whose pinout is shown in Figure 2-13.
Figure 2-13.
FBUS-HSE/H1 Power Connector Pinout
8.
Power on your FBUS-HSE/H1 LD. At power-up, the FBUS-HSE/H1
LD runs a set of power-on self tests (POST) that take several seconds,
and the green
POWER
LED is lit. For more information about reading
the POST status, refer to the
section of Appendix B,
Troubleshooting and Common Questions
Note
If you are using the third-party HSE/H1 linking device, refer to the related user
manual or reference materials to install the hardware.
Setting the Communication Parameters and
Interface Name
Complete the following steps to use the NI-FBUS Interface Configuration
utility to set the Fieldbus communication parameters and interface name.
1.
Start the NI-FBUS Interface Configuration utility by selecting
Start»
All Programs»National Instruments»NI-FBUS»Utilities»
Interface Configuration Utility
.
2.
Select the port you want to edit, and click the
Edit
button.
The NI-FBUS Interface Configuration Utility displays the default
interface name and some configuration information.
v
v
v
c
c
c
11-
3
0 VDC
Backup Power
Supply
(Optional)
+
–
+
–
11-
3
0 VDC
Primary Power
Supply
V
C
To Adjacent Device
(Optional Connection)
