Chapter 2
Installation and Configuration
©
National Instruments Corporation
2-13
NI-FBUS Hardware and Software User Manual
2.
Hook the lip on the rear of the FBUS-HSE/H1 LD onto the top of a
35 mm DIN rail and press the FBUS-HSE/H1 LD down onto the
DIN rail, as shown in Figure 2-11.
Figure 2-11.
Mounting the FBUS-HSE/H1 LD on a DIN Rail
3.
Slide the FBUS-HSE/H1 LD to the desired position along the DIN rail.
After the FBUS-HSE/H1 LD is in position, lock it to the DIN rail by
pushing the rail clip to the locked position, as shown in Figure 2-10.
4.
Connect the RJ-45 Ethernet port of the FBUS-HSE/H1 LD to an
Ethernet hub using a standard Category 5 Ethernet cable.
Note
Do
not
use a cable longer than 100 m. If you are using a 10 Mbps Ethernet, National
Instruments recommends using a Category 5 shielded twisted-pair Ethernet cable.
1
Cover
2
Lip
3
35 mm DIN R
a
il
4
Pre
ss
on to R
a
il
4
1
2
3
