Index
©
National Instruments Corporation
Index-3
ENET-232 and ENET-485 Series User Manual
diagnostics errors
See
Serial Device Server
Diagnostics utility
registration, 3-5
using with DHCP, 6-2, C-2
DNS server, 3-6
DNS table
manually configuring, C-2
manually inserting hostname, 6-3
using NSLookup, C-2
documentation flowchart, 1-1
DOS applications
using with serial device server, C-13
DTE vs. DCE, D-6
DTE-to-DCE interface, D-6
straight-through cabling in (figure), D-6
null-modem cabling in (figure), D-6
duplex architectures
full duplex, D-3
half duplex, D-4
overview, D-3
Dynamic Host Configuration Protocol.
See
DHCP
E
electrical characteristics, E-1
electrostatic discharge protection, E-2
ENET-485
advanced transceiver control for
transceiver control modes (table), 6-7
two-wire mode: auto control, 6-8
two-wire mode: DTR controlled, 6-8
two-wire mode: DTR with Echo, 6-8
changing bias resistors, 6-11
configuring transceiver modes, 6-7
connecting two- or four-wire devices, D-9
setting transceiver control mode
Linux
x
86/Solaris 2.
environmental characteristics, E-1
error messages
example, B-2
interpreting, B-1
recording, B-2
Ethernet
connecting to serial device server, 2-3
NI Ethernet device configuration, 3-1
Ethernet address
F
failure
cannot connect to network, C-5
connecting to serial device server, C-6
red PWR/RDY LED, C-4
using Serial Device Server Diagnostics
FIFO settings, 4-5
firmware
NI Ethernet Device Firmware
Update utility
determining version, C-9, C-15
updating, 6-5
Linux
x
86/Solaris 2.
four-wire mode, 6-8
frequently asked questions, F-1
front panel (figure), 1-4
full duplex, D-3
full-duplex system (figure), D-4
G
gateway settings