National Instruments ENET-232 Series, User Manual

Page: 97 / 105

© National Instruments Corporation Index-1 ENET-232 and ENET-485 Series User Manual
Index
A
adding a new serial interface
Linux x 86/Solaris 2. x , 4-3
Windows 2000/NT 4.0, 4-1
advanced transceiver control for the ENET-485
four-wire mode, 6-8
setting transceiver control mode
Linux x 86/Solaris 2. x , 6-10
Windows 2000/NT 4.0, 6-9
transceiver control modes (table), 6-7
two-wire mode: auto control, 6-8
two-wire mode: DTR controlled, 6-8
two-wire mode: DTR with Echo, 6-8
B
baud rate
maximum, C-12, C-15
setting, C-12, C-15
bias resistors
changing, 6-12
functionality, 6-11
location, 6-13
using in transmission line (figure), 6-11
C
cable connectors
DB-25, D-8
DB-9, D-7
cables
connecting, 2-3
verifying proper Ethernet cable
type, C-6, C-8
caution
using firmware update utility, 6-7
CFG RESET switch
if hosts are connected, 6-3
location, 6-3
using to enter network configuration
mode, 6-3
using to reset default network
characteristics, 6-4
COM port number
changing, 4-5
comment
to help identify device on network, 3-5
common questions
Linux x 86/Solaris 2. x , C-14
Windows 2000/NT 4.0, C-8
communication
over the serial bus, C-12, C-15
communication port settings
adding a new serial interface
Linux x 86/Solaris 2. x , 4-3
Windows 2000/NT 4.0, 4-1
configuring, 4-1
viewing or changing
Linux x 86/Solaris 2. x , 4-6
Windows 2000/NT 4.0, 4-3
communication problems
after configuring serial device server, C-11
between DHCP and DNS, 6-3
connecting to serial device server, C-6
with devices on other subnets, C-3
with NI Ethernet device configuration,
C-14, C-16
comparison to VISA API, F-1
Configuration Reset switch.
See CFG RESET
switch