National Instruments ENET-232 Series, User Manual

Page: 98 / 105

Index
ENET-232 and ENET-485 Series User Manual Index-2 ni.com
connecting
cables, 2-3, 5-3
serial devices, 2-4, 5-3
two-wire devices, D-9
contacting National Instruments, F-2
conventions,
xi
cover
removing (figure), 6-12
CreateFile API
failure, C-11
restrictions, C-11
customer
education, F-1
technical support, F-1
D
data
problems sending or receiving, C-4
DB-25 connector, D-8
pin descriptions (table), D-8
pin locations (figure), D-8
DB-9
pin descriptions (table), D-7
pin locations (figure), D-7
DCE vs. DTE, D-6
default configuration
resetting, 6-4
default hostname
location, 2-2
using to add new serial interface, 4-2
determining
firmware version, C-9, C-15
physical port associated with a
COM port, C-9
software version, C-8, C-14
Developer Zone, F-1
development tools for saving time, 1-6
Device Manager
information about serial ports, C-11
DeviceIoControl
setting transceiver mode with, 6-9
DeviceIoControl(), 6-9
input values (table), 6-9
DHCP
benefits and purpose, 6-2
configuring network settings
automatically, 2-4
configuring network settings without
DHCP, 2-5, 3-1
confirming its availability, 2-4
if DHCP does not configure network
parameters, C-1
registering hostname and IP address, 3-4
risks for failure, 6-2
using with DNS, 6-2, C-2
DHCP failure
communication failure between DHCP
and DNS, 6-3
if no IP addresses available, 6-2
diagnostic messages
Linux x 86/Solaris 2. x
VI_ERROR_RSRC_BUSY, C-8
VI_ERROR_RSRC_NFOUND, C-7
Windows 2000/NT 4.0
could not connect to serial device
server, C-6
could not directly access the serial
port, C-7
could not locally access the serial
port, C-7
environment is not configured
properly, C-5
error reading registry, C-5
failed to open network
connection, C-5
required file is missing, C-5
serial device server refused
request, C-7
diagnostic resources, F-1