Chapter 8
SC-2056
©
National Instruments Corporation
8-5
Table 8-1 describes the connectors on the SC-2056.
Table 8-1.
SC-2056 Connectors
Connectors
Connection
Description
J1
100-pin female ribbon cable
shielded connector; DAQ
device connection
Attach J1 to the DAQ device when using the
SH100-100 or SH96-100 cable.
J2
50-pin male ribbon cable
connector; DAQ device
connection (pins 1–50)
Attach J2 to the DAQ device pins 1–50 when
using the R1005050 cable.
J3
50-pin male ribbon cable
connector; DAQ device
connection (pins 51–100)
Attach J3 to the DAQ device pins 51–100 when
using the R1005050 cable.
J4
50-pin male ribbon cable
connector; analog input
channels 0–15
Attach J4 to the 50-pin accessories as shown in
Figure 8-2.
J5
50-pin male ribbon cable
connector; analog input
channels 16–31
Attach J5 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0–15. This connector uses channels
16–31 of the DAQ device.
J6
50-pin male ribbon cable
connector; analog input
channels 32–47
Attach J6 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0-15. This connector uses channels
32–47 of the DAQ device.
J7
50-pin male ribbon cable
connector; analog input
channels 48–63
Attach J7 to the 50-pin accessories as shown in
Figure 8-2. 50-pin accessories are labeled
channels 0–15. This connector uses channels
48-63 of the DAQ device.
J8
26-pin male ribbon cable
connector; digital I/O
connection
Attach J8 to the SC-206X Series or SSR
8-channel boards. This connection takes the
eight digital I/O lines from the DAQ device to a
digital signal conditioning accessory with
compatible pin connections, as shown in Figure
8-2.