Chapter 5
SC-2053
5-4
©
National Instruments Corporation
Figure 5-2.
SC-2053 Connections
Table 5-1 describes the connectors on the SC-2053.
Table 5-1.
SC-2053 Connectors
Connectors
Connection
Description
J1, J2
50-pin male connectors;
Lab/1200 connection
Attach J1 or J2 to the DAQ device. The other
connector can daisy-chain the DAQ device
signals to other 50-pin accessories such as a
CB-50 or SC-2071.
J3
26-pin male connector; 5B
Series analog I/O connection
Attach J3 to the 5B Series backplane. This
connection takes analog input channels 0–7 on
the DAQ device to channels 0–7 of the 5B Series
backplane in sequential order. The voltage output
signal DAC0OUT from the DAQ device is
connected to channel 8 of the 5B Series and
DAC1OUT is connected to channel 9.
J4
J5
J6
26-pin male connector; port A
digital I/O connection
26-pin male connector; port B
digital I/O connection
26-pin male connector; port C
digital I/O connection
Attach each of these connectors to an SC-206X
Series board or to an 8-channel SSR Series
backplane. Connectors J4, J5, and J6 connect the
eight digital lines of the port corresponding to the
label below the connector to the digital lines of
the accessory.
5B Series
SC-206
X Series or
8-Channel SSR Series
SC-206
X Series or
8-Channel SSR Series
SC-206
X Series or
8-Channel SSR Series
SC-2071
or CB-50
Lab/1200
SC-2053
B
T
R
O
P
PORT
C
PORT
A
J4
J3
J5
J6
J1
J2
Analog I/O
Digital I/O