Page 16
8274/9274 PROCEDURE
BELT (CONTINUED)
REMOVING BELT (8274 & 9274)
•Loosen bolt or bolts on one of the tension brackets (Figure A & B)
•Push in on tension bracket toward gear plate
•Belt should be loose enough to slide off
REPLACING BELT (8274 & 9274)
•Loop belt around in pattern shown (Figure C & D)
•Follow Belt Tension procedure
MOUNTING PLATE ON TO MACHINE
•Grease shaft first
•Shaft key needs to line up with key notch on plate (Figure E). To temporarily hold key in place,
secure key with an o-ring or rubber band (Figure F)
•Position machine over plate (Figure G)
•Swivel machine until key fits into plate
•Secure the four bolts on top of the shroud cover (Figure H)
•Replace the dust guard
Figure E
Figure F
Figure G
Figure H
Figure B
Figure A
Figure C
Figure D
Center Pulley
8274
9274
Brackets
Key Notch
O-Ring
