InstantWave
High Rate
11Mbps
Access Point
17
IP:
Note: These SNMP related settings are only useful for network management and
remote configuration (APMS). For proper wireless connections, these
settings don’t have to be changed.
From the IP card (
Figure 12
) you may view or modify the Access Point’s TCP/IP
address, configure its subnet mask, or add a default gateway (see the note below).
Note: An AP will directly transfer SNMP respond packets (confirmation packets)
to an APMS PC if it is within the same LAN (the same subnet mask). If an
SNMP respond packet from an AP is destined for an APMS PC on another
LAN, then the SNMP respond packet needs to go through a router-gateway.
The default gateway is the path to that router. If you set the correct default
gateway, then you can use an APMS manager (i.e. a PC running APMS)
physically located in a different subnet to manage this AP.
IP Address
InstantWave High Rate Access Points are delivered with
a default IP of 192.168.1.1
Consult your network administrator for exact settings.
Subnet Mask
InstantWave High Rate Access Points are delivered with
a default subnet mask of 255.255.255.0
Consult your network administrator for exact settings.
Default Gateway
Enter the default gateway address here (if required)
If you wish to change the defaults, set each AP to its new IP address before
introducing it to the open network. All APs within the same network must have
the same TCP/IP subnet address.
