15
Set Up
Male Catheterization
Male Catheterization
& Prostate Examination
Features included with
LF04301, LF04302, and
LF04302EX.
The male genital
insert can represent
an uncircumcised or
circumcised adult male,
with the addition of
Fig 33.
Fig 32.
Fig 29.
the included foreskin. To change genitals in the
simulator, simply press to fit into the open genital
area of the pelvis. (See Figure 29).
The urinary catheterization reservoir is
interchangeable between male and female genitals.
Female Genitals come installed with the simulator.
3. Hang the filled Fluid
Supply Bag. Attach
the tubing quick
connect on end of
Fluid Supply Bag to
the quick connect
on the left lower side
of the simulator’s
torso.Open Clamp
on fluid supply bag
(See Figure 32).
Note: The Fluid Supply
Stand is not included.
Use distilled water or
follow instructions on
the Simulated Urine.
4. Lubricate the
catheter being used
with the Pump
Spray Lubricant
Fig 31.
provided (See Figure 33). The catheter should
be well lubricated and force should not be used
when placing the tube.
Note: Special care should be taken when using
a Foley catheter. Nasco recommends use of 16
French Foley catheters. Use of this size will avoid
the possibility of leakage. Cuff inflation should only
be attempted when the catheter is in the proper
position inside the bladder. The cuff must also be
completely deflated before the catheter is removed.
The catheter should not be left inserted in the
simulator for an extended period of time. Improper
use of a Foley catheter may result in damage to the
simulator and void the warranty.
5. After completion of the exercise, close the clamp
on the Fluid Supply Bag tubing and remove the
male genital insert by reversing the assembly
instructions. Disconnect the urinary catheter
reservoir tubing via the quick disconnect, remove
the reservoir from the male genitalia insert, and
drain the reservoir thoroughly (See Figure 30).
6. Rinse the reservoir and the outside of the male
genitalia to remove any residual lubricant.
Fluids should be drained and the reservoir emptied
after every use. Ensure the reservoir is clean and dry
prior to storing.
Note: To apply the
foreskin, apply the
included pump spray
lubricant to the glans
and slide the foreskin
in place.To prepare for
catheterization exercises:
1. The urinary resevoir
is installed on the
back side, make sure
the urinary resevoir is
firmly in place. (See
Figure 30).
2. Close the clamp on
the Fluid Supply Bag
(See Figure 31) and
fill with water or
included simulated
urine. Recommended
amount of fluid to fill
the Fluid Supply Bag
is between 100 and
250 mL.
Fig 30.
