![Nasco TERi LF04300 Instruction Manual Download Page 31](http://html.mh-extra.com/html/nasco/teri-lf04300/teri-lf04300_instruction-manual_707791031.webp)
31
Set Up
Auscultation
Listening to Selected Heart and Lung Sounds
1. Follow the instructions above to activate remote
control, SmartScope
™
, and select desired sounds.
2. Place the earpieces of the SmartScope
™
in ears
angled in a forward position.
3. Place the diaphragm of the SmartScope
™
over
the appropriate sites on the manikin.
4. Use included laminated key cards for location
instruction.
5. For additional location instruction, use the green
color-coded stickers for lung sites found and the
blue color-coded stickers for the heart sites found.
6. Correct placement of the SmartScope
™
is
required to hear the sounds. Moving the
SmartScope™ slowly across the area will help
locate the sensor in the torso so that the sounds
can be heard.
Note: The SmartScope
™
is only for use with
the Auscultation feature. It is not a standard
stethoscope. (See Figure A)
Using the Amplified Speaker (purchased
separately LF01189U)
1. Locate the SmartScope
™
and speaker cord
included with the 30-watt amplifier/speaker.
2. Plug the speaker cord into the speaker jack on
top of the SmartScope
™
box.
3. Plug the amplifier/speaker into the 110V (or 220V)
power source.
4. When the speaker is connected, the
SmartScope
™
earpieces will not work; sounds will
only be amplified through the speaker.
5. Select the desired heart and lung sounds
following the instructions above.
6. Place the diaphragm of the SmartScope
™
over
the appropriate sites on the manikin.
Note: The remote has a battery saver mode that
shuts the unit down after eight minutes if the
remote is left on the same setting. To prevent this
shutdown, select a different heart or lung sound
within the eight-minute time period.
Care and Maintenance for Auscultation Feature
1. Prior to storing equipment, ensure the batteries
in the remote control and SmartScope
™
are
removed.
2. Adhesive remaining on the manikin from use
of the blue and green location stickers can be
removed using Nasco cleaner. Apply Nasco
Cleaner to a clean, soft, dry cloth and wipe
residual adhesive. Be cautious not to over-wipe
painted areas.
3. Newsprint, ballpoint pen, and printed plastics will
leave an indelible mark.
4. Alcohol prep pads are included to sterilize
SmartScope
™
earpieces between users.
Fig A.