NARVI SAANA, Installation And Instruction Manual, Page: 19 / 44

INSTALLATION AND OPERATING
INSTRUCTIONS
black stainless steel
NARVI SAANA 6,8kW 903003 903013
NARVI SAANA 9kW 903005 903015
GB
Please read the manual carefully before you start installing and using it and keep the manual for future
reference. The products are meant only to be used as a sauna heater and for heating the sauna.
1. THE ELECTRIC HEATER SET INCLUDES:
1. Heater with control unit
2. Fastening plates and fastening screws
3. Temperature sensor
4. Control unit
5. Installation and operating instructions
2. BEFORE INSTALLATION:
Check on the following:
– Make sure the capacity of the heater (kW) corresponds to the size of the steam room (m
3
).
– Table 1 shows the heater types that correspond to various size saunas.
– If the steam room has any non-insulated brick, tile or glass surfaces, 1.5 m
3
of space must be added
to the size of the steam room for every square-meter of such surfaces. Based on the result, choose
the heater with the required capacity shown in table 1.
When choosing a heater, strictly adhere to the steam room space shown in table 1.
Table 1. Installation information for SAANA heaters
– The minimum height of the steam room and minimal safety clearances are shown in table 1.
– Make sure that the surface onto which the fastening plates are being screwed is sufficiently strong.
Thin boarding is not sufficient. The surface can be reinforced with a supporting framework under
the boarding or reinforcing boards on top of the wall, which is connected to a wall framework.
– The heater can also be installed into a wall recess, see figure 1.
- The floor under the sauna heater must be heat resistant. Hot pieces of the stones might drop on
the floor from the heater and cause fire risk.
ONLY ONE ELECTRIC HEATER MAY BE INSTALLED IN EACH SAUNA ROOM.
Heater model Capacity Sauna room Minimal safety clearances to the heater Quantity
of stones
Connection *)
Volume Height on the
sides
at the
front
to the ceiling to the floor 400 V
3N
Fuses
min max min A **) B **) C **) D **)
kW m 3 m 3 mm mm mm mm mm kg mm 2 A
SAANA 903003
SAANA 903013
6,8 5 8 1900 120 120 970 30 80 5x1,5 3x10
SAANA 903005
SAANA 903015
9 8 14 1900 120 120 970 30 80 5x2,5
3x16
**) See figure 1 *) Connected with rubber cable, type H07RN-F
or corresponding cable
TECHNICAL DATA:
- width 320 mm
- depth 300 mm
- height 930 mm
- weight 10 kg
(without stones)