W415-1013 / C / 11.19.13
33
EN
REQUIRED COMPONENTS:
• HMF150/200 Hybrid Furnace
•
HMFK-BMP50
Blower
Box
Module
• HMFK-EF15, -EF18, -EF20, -EF25 Electric Furnace Module
(HMFK-EF15 for the HMF150 only, and HMFK-EF25 for HMF200 only)
• HMFK-SOLID or HMFK-GLASS Door Kit
STEP #5
○
Completely assemble HMF150/200 in required left or right hand "RA"
con
fi
guration as required.
○
Locate and level HMF150/200 while maintaining minimum 1.25"
(32mm) clearance space between bottom of furnace and
fl
oor.
○
Use the levelling legs to compensate for uneven
fl
oor and snug the
lock nuts up to furnace base to prevent movement through vibration.
STEPS #1 - #4
Follow Steps 1 to 4 from SECTION 5.1 - HYBRID HMF150/200 AS AN "ADD ON" TO EXISTING FURNACE.
STEP #6
○
Remove contents of the blower module kit and compare with contents list on "manual" addendum accom-
panying the blower module.
STEP #7
○
Remove contents of the electric furnace module kit and compare with contents list on "manual" addendum
accompanying the electric furnace module. Refer to step 1.2 for installation instructions for the pressure
differential switch probe according to either left or right RA con
fi
guration.
STEP #8
○
Place the blower module and the electric furnace module beside each other as per diagram:
LOCK NUT
LEVEL LEG
ELECTRIC FURNACE
CONTROLS
ELECTRIC FURNACE
MODULE
BLOWER HOUSING
MODULE
LEFT HAND RA CONFIGURATION
RIGHT HAND RA CONFIGURATION
○
Align holes in the adjacent top and side
fl
anges,
and secure with 9 x 1/2" hex head wildrill screws.
NOTE
Top/bottom
fl
ange screws thread into blower. Side
fl
ange screws thread into electric unit.
STEP #9
○
Place the open side of electric furnace against rectangular inlet window on the side panel of HMF150/200
furnace. Adjust the levelling legs on the blower box module so that the electric furnace module is level and
holes on the mounting
fl
anges align with pilot holes on side of furnace panel.
5.4 HYBRID HMF150/200 AS A COMBINATION “WOOD/ELECTRIC” FURNACE
H3.50
ENSURE ELECTRIC FURNACE CONTROL BOX ACCESS PANEL IS FACING TO THE FRONT OF THE
UNIT WITH THE ELECTRICAL HEATER COILS TO THE BOTTOM.
