Napoleon GDS60-1N, Installation And Operating Instructions Manual

Page: 41 / 124

41
EN
W415-1328 / A / 01.05.16
6
7
Position the notch located in log #6 against the grate
post.
Place the bottom of log #7 against the right outermost
grate post and the top into the pocket provided on the
center log (#6). Bend up the tab in the log support to
cradle log #7. Tear the glowing embers into pieces
and place onto the front of the burner. Care should
be taken to shred the embers into
thin, small irregular
pieces
as only the exposed edges of the fi bre hairs
will glow when exposed to direct fl ame; however care
should be taken to not block the burner ports. Blocked
ports can cause an incorrect
fl ame pattern, carbon
deposits and delayed ignition.
Log colours may vary. During the initial use of the
appliance, the colours will become more uniform as
colour pigments burn in during the heat activated
curing process.
POSITIONING THE LOGS IMPROPERLY WILL
CAUSE FLAME IMPINGEMENT AND CARBONING.
The notch in log #5 should be pressed down onto
the skewering pin located at the end of the grate as
shown to prevent it from rocking. Place log #1 onto the burner, centering it onto the
burner tray and pushing it as close to the rear wall
of the
fi rebox as possible. Move logs # 2 and 3 into
position, lining up the studs located on the burner
with the holes on the bottom of the logs. Sit the notch
at the bottom of log #4 against the left outermost
grate post and position the top of the log into the
pocket provided on the rear log (#1).
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Phazer
tm
logs
glow when exposed to direct fl ame and provide a unique and realistic glowing effect. Use only certi fi ed phazer
tm
logs available from your Napoleon® dealer.
6.6 LOG PLACEMENT
4
2
3
1
5